Untitled experiment

Mode basis

Source

Select component...

From component

Select component...

To component

Select component...

SamplesBranch (optional)

The profile is sampled from the beam the backend actually traced between these two components, including through any resolved cavity. Where several branches connect them, select one: they are physically different paths.

No beam profiler result for "Profile plot" yet. Set the run up above, then run it.

Field source

Select component...

Decompose at

Select component...

Maximum mode orderBranch (optional)Image grid points (optional)

Declare source modes on the laser, select where the beam should be read, and choose the maximum order to report.

No higher-order modes result for "Modal spectrum" yet. Set the run up above, then run it.

Piezo actuator

Select component...

Start (nm)Stop (nm)Samples

Maximum mode order

Place a mirror to sweep. Any mirror can carry a piezo; which resonator it belongs to is worked out from the scene.

No piezo analysis result for "Scan plot" yet. Set the run up above, then run it.

Scene

Properties

Untitled experiment

Set incidence angle